When testing high draw accessories like blower motors, wiper motors, seat heaters and rear window defoggers, professional use an inductive clamp because their meters simply can’t handle those higher current draws. If the component draws more than that, you will blow the internal fuse in your meter.

Most multimeters are limited to reading a maximum of 10-amps. That’s because auto electrical accessories you might want to current test will usually draw more than 10-amps. There are very few instances for using this setting in auto diagnostic work. Multimeter setup for 10 or less amps (top row right image in above photo) Plug the red lead into the VΩmA port and the black lead into the common (COM) port. Multimeter setup for Ohms (Ω) resistance (top row middle image in above photo)Īutomotive resistance for sensor is often fairly low so it’s usually best to start testing with your meter at the lowest Ω setting. Since auto voltage is usually below 15.5 volts, set the meter dial to the 20 DCV setting. And, when the end hotkey is pressed, the auto-clicking stops.Multimeter setup for volts and polarity (top row left image in above photo)Īutomotive voltage testing is usually done with the meter set to DC volts or DCV. Select the enable box so that when they start hotkey is pressed, the auto-clicking starts. In the end, you can save the macro to the list. The Macro can any number of times or keep running until the user presses the keyboard shortcut key. If you wish to add more mouse clicks, then repeat the above process.Īfter adding all the mouse clicks to the macro, mention the name of the robot, initiate the hotkey, and repeat the macro. Then you need to mention the type of the click - left click of the mouse, right-click, double click, release the click, click and hold.įinally, click on ‘Add Click’ to add it to the macro. Lesser value of Click Interval means faster clicks. Thereafter, click on the ‘Click Interval’ spin button to set the time between the two clicks. This particular point will get updated in the Add Robot window. You can do this by moving the mouse to the targeted place and pressing any keyboard key. First, click on the ‘Add Robot’ button to add the Auto Clicker’s macro.

How to use free auto clicker